Speed Selection; Control Panel - Panasonic EY7460 Manual De Instrucciones

CAUTION:
Set the clutch setting at this mark ( )
before actual operation.

Speed Selection

Choose a low or high speed to suit
the use.
LOW
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
CAUTION:
• Check the speed selector switch
before use.
• Use at low speed when high torque
is needed during operation. (Using
at high speed when high torque is
required may
breakdown.)
• Do not operate the speed selector
switch (LOW-HIGH) while pulling
on the speed control trigger. This
can cause the rechargeable battery
to wear quickly or damage the
internal mechanism of the motor.
* See specifications for "MAXIMUM
RECOMMENDED CAPACITIES".
CAUTION:
• To prevent excessive temperature
increase of the tool surface, do not
operate the tool continuously using
two or more battery packs. The tool
needs cool-off time before switching to
another pack.
• Do not close up vent holes on the
sides of the body during operation.
Otherwise, the machine function is
adversely affected to cause a failure.
• Do NOT strain the tool (motor). This
may cause damage to the unit.
• Use the tool in such a way as to
prevent the air from the body vent
holes from blowing directly onto your
skin. Otherwise, you may get burned.
HIGH
cause a motor
Bit-locking Function
1. With the trigger switch not engaged
and a screwdriver bit locked in
place, the tool can be used as a
manual screwdriver (up to 40 N
408 k f-cm, 353 in-lbs).
g
There will be a little play in the
chuck, but this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque
than the maximum torque of the
driver (position
confirming the tightness of a screw
or to loosen an extremely tight
screw.

Control Panel

(1)
(1) LED light
CAUTION:
• The built-in LED light is designed to
illuminate
temporarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool has
not been used for 5 minutes.
- 9 -
on the clutch), for
(3)
(2)
Before the use of LED light,
always pull the power switch
once.
Press the LED light
button.
The light illuminates with
very low current, and it does
not adversely affect the
performance of the tool
during use or its battery
capacity.
the small work
·
m,
area