Assembling The Difrax Breast Pump; Assembling The Splitter D; Connecting The Milk Tube; Connecting The Air Tube - Difrax 611 Manual De Usuario

UK

Assembling the Difrax Breast pump

Assemble the splitter according to the diagram below:
D
Splitter
D
D1. Cap
D2. O-ring
D3. Float switch O-ring
D4. Float switch
D5. Screw cap
D6. Milk valve
D
1) Assembling splitter .
D
a) Insert ring D2 into cap D1.
b) Place the float switch O-ring D3 onto float
switch pin D4.
c) Place the float switch D4 with O-ring D3
downwards into cap D1.
d) Turn screw cap D5 onto cap D1.
e) Place milk valve D6 in the bottle (see figure A).
Tip: Shake the splitter for a few seconds.
D
Can you hear it rattling? That means it is fitted correctly.
D1
D2
D3
D4
D5
D6
Figure 1
Figure A
6
f) Screw the splitter onto
D
the bottle.

2) Connecting the milk tube.

Push one end of the milk tube all the way
E
on the connector on the side of the splitter
displaying the word 'Milk'.
Push the other end of the milk tube
E
on the connector on the outer shell
B
Tip: The tip of the milk tube is white.
E

3) Connecting the air tube.

Push one end of the air tube all the way on the
F
connector above the splitter displaying the
D
word 'Air'.
Remove the protective cap from the pump
N
(Store the protective cap in a safe place for
A
transporting the breast pump).
Connect the S-baby bottle to the pump
G
clicking the edge of the bottle sideways into place.
Push the other end of air tube on the connector
F
on pump .
A
D
all the way
.
by
A
7
UK