Water Mode; Visual And Audio Feedback - Black and Decker PlantSmart Manual De Instrucciones

Monitor Mode GET YOUR RESULTS
11. After the watering cycle is complete, press the START/STOP button on the plant sensor to stop collecting data. The sensor will make three descend-
ing tones and the yellow light will blink five times.
• Plug the plant sensor into your USB port using the USB cable that was included.
• The PlantSmart website automatically launches and a dialog box opens for you to save your reading.
• Name the location where you had the plant sensor (such as "front window" or "left corner of front planter".) This information helps you keep track of where
you have placed the plant sensor.
• Select whether the location was INDOORS or OUTDOORS.
• Click the SAVE button.
• You will be taken to the PLANT DOCTOR tab within My Readings.
• PlantSmartʼs web site examines the data recorded by the plant sensor. The analysis corrects for any weather conditions, and takes into consideration
where you live. The website will provide you with easy-to-follow gardening advice to improve the health of your plant. You can also view the sunlight,
temperature, moisture, and soil condition information collected by the plant sensor on the PLANTʼS VIEW tab. View other plants that would thrive in this
location by clicking on the TOP RECOMMENDATIONS and ALL RECOMMENDATIONS tabs.
1. Plug your plant sensor into the USB port on your computer using the USB cable that was included. You will automatically be logged in to the MY

Water Mode

SET UP
PLANTSMART Dashboard page.
2. Click on the "WATER" button at the far right of the screen to set your plant sensor to Water mode. Water mode quickly determines if your plants need
immediate watering or not. NOTE: Water mode does not work for cacti or orchids.
3. When instructed, remove the sensor from the USB port and put the plant sensor together (top and bottom).
4. Press the START/STOP button on the sensor to begin Water mode. HOLD THE SENSOR BY THE TOP. The sensor light will blink green and the
sensor will emit three ascending tones to let you know that it is in Water mode. The light will stay green while it is on.
5. Insert the soil sensor fully in the soil near the roots of the plant whose moisture level you wish to check.
6. If a plant needs water, the sensor light will blink yellow and will make a chirping sound. Water the plant well if you hear this sound. If the sensor light
stays green, then that plant does not need water.
7. You can then move on to another plant by lifting the plant sensor out of the soil, and placing it in the soil near a different plant.
8. Continue to move the plant sensor from plant to plant to determine if they need watering.
9. When done checking plants that might need watering, press the START/STOP button. There is no need to press the START/STOP button for every
plant.

Visual and Audio Feedback

Mode
Connected to Computer
Inserting Battery
Connected to Computer
Disconnecting from
Computer
Recommend Mode
Recommend Mode
Recommend Mode
Monitor Mode
Monitor Mode
Monitor Mode
Monitor Mode
Monitor Mode
Water Mode
Water Mode
Event
Companion Software not
installed
Closing battery door
Sensor attached to USB
Sensor detached from
USB
Press start button
Press stop button
Taking a reading
Press start button
Press stop button
Taking a reading
Needs watering
Too much water
Needs watering
Doesn't need watering
Visual
Solid yellow
No light
Blink Green
No light
Blink Green
Blink Yellow
Blink green once every 5 sec No sound
Blink Green
Blink Yellow
Blink green once every 5 sec No sound
Blink yellow
Blink yellow
Blink yellow
Blink green
5
Audio
Up tone
Ba-beep
Up tone
Down tone
Up tone
Down tone
Up tone
Down tone
Siren
Warning
Siren
No sound