Arcadia ULTRA SEAL Instrucciones De Seguridad, Instalación Y Mantenimiento página 5

Ultra Seal Instructions 99x210
Do not install or store the appliance where it will be exposed to the
weather or temperatures below freezing.
Make sure the luminaire is mounted securely on the tank before operating it.
Read and observe all the important notices on the appliance.
DO NOT SUBMERGE ANY PART OF THIS LUMINAIRE!
SAVE THESE INSTRUCTIONS
Lamp Installation
Your luminaire is not supplied with a lamp. We recommend that the
relevant wattage and colour Arcadia lamp is used. Please ensure that the
correct wattage lamp is used.
Unplug the luminaire before installing the lamp.
To install a lamp:
- unscrew the ring from each Ultra Seal
- fit the rings onto either end of the lamp as shown in illustration 2
- align pins on lamp to the lampholder holes and insert the lamp by
pushing the lamp directly into the lampholder (see illustration 2).
- screw the rings tightly onto the lampholder body. Do not twist the
lamp within the lampholder (see illustration 3).
The ring is fully tightened when there is no gap between the ring and
the body (see illustration 4 & 5).
Ensure that the ring is not cross-threaded (see illustration 6).
To remove the lamp, switch off and unplug the supply, undo the ring
from the lampholder body and pull the lamp directly out from the
lampholder. Do not twist the lamp in any way (see illustration 7).
Never use this Ultra Seal
NOT SUITABLE FOR USE WITH UVC LAMPS.
Physical Installation
Select a suitable site close to your electricity supply. Always place the
controller on it's base in an upright position (see illustration 8).
Place the controller on a firm surface and NOT on carpets or similar
fabric surfaces.
Fitting the mounting brackets:
Use suitable fixings for the mounting surface. For mounting dimensions, refer
to illustration 9.
The mounting bracket is suitable for a vertical or horizontal mounting
surface - please ensure that the lampholder cable and insulation
remain unstressed, (see illustration 10, 11 & 12).
Do not mount directly to the aquarium glass.
8/12/05
®
lampholder
®
controller without lamps in place.
09:16 Page 8
3
(Black