Arcadia ULTRA SEAL Instrucciones De Seguridad, Instalación Y Mantenimiento página 7

Ultra Seal Instructions 99x210
Trouble shooting
If the luminaire does not light:
Check that the mains power is connected and switched on both at the
wall and at the switch on the controller body.
Check that the luminaire is rated for the same supply voltage that you
are using.
Check that the lamp is of the correct wattage and type for the luminaire.
Check that the lamps are installed correctly.
Check that the starter is working (will require replacement from time
to time). The starter switch in the top of the Ultra Seal
a simple twist fit mechanism.
Check the fuses in the mains supply.
If the lamp still fails to light, replace the lamp (always replace the
starter at the same time).
Maintenance
The luminaire can get warm. Allow adequate time for it to cool before
attempting any maintenance.
CAUTION! Disconnect the mains lead of the luminaire before putting your
hands in the water or opening the luminaire for maintenance.
If the mains lead of this luminaire is damaged, it should be exclusively
replaced by the manufacturer, his service agent or a similar qualified
person in order to avoid a hazard.
This appliance has no user serviceable parts.
Cleaning:
Always clean the luminaire when it is disconnected from the supply,
and it is cool.
Both the appearance and performance of your luminaire can benefit
from regular cleaning.
A damp cloth is normally adequate to clean the lampholders and lamp.
Excessive salt deposits can be removed with a wet cloth.
Only use the recommended lamp type for the purchased unit.
Replacement parts:
Replacement starter
Replacement sealing rings (pair)
8/12/05 09:16
®
T5 (16mm/5/8")
T8 (26mm/1")
Page 10
controller has
- ABFSU
- AB5R
- AB8R
5
(Blac