Ferax FBS-810 Manual De Instrucciones página 26

GB
"live" and could give the operator an electric
shock.
• If you are working with the sanding
machine, wear always ear protectors and
dust mask.
• The sanding machine is not suitable for
wet sanding.
• Check if the switch is not in position "ON",
before you connect the mains plug to the
mains voltage.
• Keep the mains lead always away from
moving parts of the tools.
• Use safety glasses, especially when you
sand above your head.
• Do not bring pressure to your machine, this
will only delay the sanding.
 C ontactorinhalationofdustcoming
freeduringsanding(e.g.leadpainted
surfaces,woodsandmetals),can
endangerthehealthofoperatorand
bystanders.Alwayswearappropriate
personalequipmentasadustmask
andusethedustbagduringsanding.
Immediately switch off the machine when:
• Excessive sparking of the carbon brushes
and verticiliosis in the collector.
• Interruption of the mains plug, mains lead
or mains lead damage.
• Defect switch
• Smoke or stench of scorched isolation
Electrical safety
When using electric machines always observe
the safety regulations applicable in your
country to reduce the risk of fire, electric shock
and personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
 A lwayscheckthatthepowersupply
correspondstothevoltageonthe
ratingplate.
 C lassllmachine.Yourmachineis
doubleinsulated;thereforeno
earthwireisrequired.
replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
26
is dangerous to insert the plug of a loose cable
in the wall outlet.
using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The
minimum conductor size is 1.5 mm
using a cable reel always unwind the reel
completely.
3. oPErATIoN
 A lwaysobservethesafetyinstructions
andapplicableregulations.
Choice of the sand-paper
Coarse sand-paper (grain 50) removes in
general the bigger part of the material and
fine sand-paper is used for the finishing. If
the surface is not even, then start with rough
sand-paper. Further you use middle coarse
sand-paper(grain 80) to remove the scratches
left behind by the coarse sand-paper and
finally you take fine sand-paper (grain 120) for
the finishing.
removing and Installing the sanding belt
Fig. C1 + C2
 B eforeassemblythesandingbelt
alwaysremovetheplugfromthe
mains.
• Put the machine on its side, with the drive
belt cover down wards.
• Loosen the sanding belt fastener (4).
• Remove the sanding belt from the machine
• Put a new sanding belt on the machine,
make sure that the direction arrows on the
sanding belt are pointing in the same
direction as the direction indicator (5).
• Fasten the sanding belt fastener again (4).
Aligning the sanding belt
Fig. B
If the sanding belt doesn't run parallel with
the outer edge of the housing, the sanding
belt must be aligned. Move the sanding belt
in the correct position with the adjusting knob
(12). By turning the adjusting knob clockwise
the sanding belt will move to the inside and
. When
2
Ferax