AVS Electronics OUTSPIDER PA Manual De Instrucciones página 39

Ocultar thumbs Ver también para OUTSPIDER PA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Lens change
With Wide angle lens (cod.FR09-0001-30):
w
opening 90°, capacity 15 m, recommended
installation height about 2.20 m.
With Barrier lens (cod.FR09-0002-30):
w
opening 5°, capacity 15 m, recommended
installation height about 2.20 m.
With Long range lens (cod.FR09-0003-30):
w
opening 5°, capacity 23 m, recommended
installation height about 2.20 m.
With Animal alley lens (cod.FR09-0004-30):
w
opening 90°, capacity 15 m, recommended
installation height about 1.50 m.
The lens code is imprinted inside
a long side of the actual lens
1.
Remove the 6 set screws.
2.
Remove the lens support.
3.
Unhook the lens from the
support by slightly pressing on the
four side stops.
4.
Insert the selected lens
verifying that the four side
stops are in their seat.
5.
Fix the 6 set screws once again
6.
Reposition the lens
support in its seat
verifying that the two
notches are correctly in
their guides.
Fixing the board
1.
the notches
A
A
MW
NOTE: Due to the mechanical tolerances of the
various compo0nents it is possible that indicated
references relating to installation height are
slightly off.
IMPORTANT: For optimal coverage adjustment,
keep the board in proximity of the reference notch
for pre-set height and act on the joint to reach
suitable inclination.
3.
Fix the board once it is
positioned at the pre-set point.
- 39 -
Insert the board until
A
coincide
B
with the stops
.
B
2.
board downward
1.0
until the pre-set
1.5
2.2
installation height is
2.7
reached.
B
E
N
Slide the
G

Publicidad

Tabla de contenido
loading

Tabla de contenido