Numark NDX900 Guia De Inicio Rapido página 2

NDX900 AND TRAKTOR LE 2 SETUP
1. DRIVER INSTALLATION (WINDOWS USERS)
1. Insert the included software installation disc into your computer's DVD-ROM drive.
2. Navigate to the ASIO4ALL directory and find the ASIO4ALL.exe file.
3. Follow the on-screen prompts to install the included low latency ASIO4ALL driver.
2. SOFTWARE INSTALLATION (TRAKTOR LE2)
1. Insert the included TRAKTOR LE 2 software installation disc into your computer's DVD-ROM drive.
Windows: Double-click "My Computer" then double-click the disc. Once the disc's contents are shown, double-
click the TRAKTOR LE 2 installer file (.exe).
Mac: Double-click the disc. Once the disc's contents are shown, double-click the TRAKTOR LE 2 installer file
(.dmg).
2. Follow the on-screen instructions to install the software.
Note: TRAKTOR LE 2's install "wizard" may ask you to install a hardware driver. Click "Next" or "Continue" to
skip past these screens.
3. Connect your NDX900 to your computer. (If you are using Windows, you may see several dialog boxes in the
corner of your screen indicating it is "recognizing" the hardware for the first time. Wait a minute until this is
complete.)
4. Open TRAKTOR LE 2. In the window that appears, click the "Activate" button to register the software. The Native
Instruments Service Center will launch. (You will need to be connected to the internet to access the Service
Center to register your software.)
5. In the Service Center login window, click "Create new User Account" (if you do not already have one) and follow
the on-screen instructions to complete your registration. (You will need the serial number on the included DVD
sleeve to do this.)
Note: For additional assistance and information, you can find TRAKTOR LE 2's manual by going to the software's
"Help" menu.
3. NDX900 SETUP
1. Connect the NDX900 Controller to a rear USB Port on your computer. Power on the NDX900 Controller.
2. Press SOURCE.
3. Rotate the PARAMETER knob until the screen reads <<SOURCE>> USB-MIDI.
4. Press the PARAMETER knob (like a button) to confirm your selection.
5. To set the NDX900 to be the default playback device:
Windows XP: Go to the Windows Control Panel
Playback device select 'USB Audio Codec'. Tick the box for 'Use only default devices'.
Windows Vista: Go to Start
highlight 'Speakers- USB Audio Codec'. Click Apply to accept the settings.
Windows 7: Go to the Windows Control Panel
Codec'.
Mac OSX: See the AGGREGATE DEVICES section.
6. Set NDX900 as your default playback device. Follow the same steps above if you have a second NDX900
controller.
AGGREGATE DEVICES (MAC)
1. Click on the Mac desktop so that Finder is displayed in the upper-left of the screen.
2. Select the Go menu from the top of the screen and choose Utilities.
3. In the window that opens, double click Audio MIDI Setup.
4. Once the Audio MIDI Setup utility is open, select the Audio tab and at the top of the screen; select the Audio
menu and choose Open Aggregate Device Editor.
5. In the window that opens, click the + button.
6. Under Structure should be listed four USB Audio Codec devices. If using two NDX900s, they will be listed as
each having 2 inputs and each with two 2 outputs. Place a check next to each of the four USB Audio Codec
devices that are listed. This will merge all four USB Audio Codec devices into one device, allowing TRAKTOR
LE2 to access all of the inputs and outputs at once.
7. Click Done.
Sounds and Audio Devices
Control Panel Sound (in Classic View). Then, click on the Playback tab and
Sound and for the Playback tab select 'Speakers- USB Audio
2
Audio tab and for the default