Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Lenox Lockers™ Pedestal Bench
WARNING
Install only on a level, secure floor surface. Do not attempt to mount on wall or
other vertical surface. Make sure all floors are clean and smooth. Remove loose
impediments, such as protruding nails, and other debris which could affect
installation. The bench will be as level as the floor it is secured to. Do not use
shims to level the pedestal bench.
Read this installation manual completely to ensure proper installation. When finished
with the installation, file this manual with the owner or maintenance department.
Installation
Compliance and conformity to local codes and ordinances is the responsibility of the
installer.
Separate parts from packaging and make sure all parts are accounted for before
Packing List
•
discarding any packaging material. If any parts are missing, do not begin installation
•
•
IS
T H
•
E
S ID
U P
until you obtain the missing parts.
Accuracy is important when drilling the flange holes.
Review your layout drawings and verify the number of pedestal benches and
components before beginning installation. Refer to your submittal layouts for proper
placement of the pedestal benches.
11/30/01
TAM
E T
A
D
N
. O
CHANGE
N /
C
D
. R
APP.
UNLESS
OTHERWISE
TOLERANCES-
DATE
NTS
DRAWN BY
.
3 PLACE
SPECIFIED:
.010
+
-
FIRST
SCALE
.
CH'K'D
DATE
.
2 PLACE
.015
-
+
USED ON
REFERENCE
.
APPR'D
.
ANGLES
FRACTIONS
.015
2˚
-
+
- +
ACAD #
SAME
DATE
.
DO NOT
MATERIAL SPEC.
SEE BOM
DRAWING
SCALE
.
NAME
LOCKER ASSEMBLY
STD. HANDLE - VENT
PART NO.
LK187218-1HV
Product warranties may be found under "Products" on our web site at www.
bradleycorp.com.
Pre-Installation Information
Tools Required
• Tape measure
• Power Drill
• 3/16" drill bit
• 1/4" masonry drill bit
• Phillips driver bit
Hardware (provided by Bradley)
2
IMPORTANT
WARNING
Failure to comply with these instructions,
or failure to use the hardware provided,
may result in personal injury and/or
property damage.
4/4/2012
Bradley Corporation • LK-INSTR-003 Rev. D; EN 12-13-001
FAST-LF017
1/4" x 2-1/4" lg. stud with nut and washer for securing
the pedestals to the floor
FAST-S357
#14 x 1-3/4" lg. screw for attaching the pedestals to
the bench
Installation
Publicidad
Tabla de contenido
