König Electronic CMP-SMARTRW10 Manual De Uso página 2

Introduction Smartcard Reader
This model enables data transmissions through the USB interface, and
realizes secure and fast smart card transactions. This reader/writer is perfect
for personal smart card use, such as authentication or electronic payment.
This smart card reader / writer is an easy way to make existing PC's smart
card capable. The smart card reader has the potential to enable smart cards to
become a viable form of payment on the internet.
Installation Manual for the Smart Card Reader
The installation steps of the Smart Card Reader's setup driver:
If the driver of the smart card reader has been installed before, please delete
the program, restart the computer and reinstall the setup driver of the smart
card reader.
When you restart the driver don't restart the computer. Restarting will cause
the installation program to fail.
Step one: Put the CD into the CD-ROM and choose (double-click) "Driver.exe"
program to start launching driver setup.
Step two: System will begin to install the driver (the progress could take
several minutes)
Step three: When the desk is shown the "finish", please click it; i.e. finish the
installation
Step four: When installation is confirmed well, you can begin to use it
normally.
Step five: Connecting the smartcard reader will shown "EMV certified USB
Smart Card Reader" on the system.
Step six: After installing, there will be shown "the new system is installed well
and can begin to use"
Remarks: After it, you can check whether there is the "Generic USB Smart
Card Reader" folder on the "Set Administrator".
1