Installing The Cd-R/Rw Drive; Connecting The Cables - Samsung SW-224 Guia Del Usuario

SW-224_eng-02 12/19/01 4:42 PM Page 6

Installing the CD-R/RW Drive

To install your CD-R/RW drive in the PC, proceed as follows.
1
Make sure that the PC is powered off and disconnected from any power source.
2
If necessary, attach a horizontal bracket to both sides of
the drive.
Use of the brackets depends on your computer
model; you can purchase these accessories
separately from your computer dealer.
3
Remove the cover from a free expansion slot and install
the CD-R/RW drive, as shown in the illustration.
If you have no free expansion slot, install the drive in
place of the diskette drive.
CD-R/RW drive

Connecting the Cables

1
Connecting the power cable
The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the CD-R/RW drive.
6
2
Installing a jumper on the master/slave select terminal
Install the jumper in the correct position on the terminal:
MA to use the device in the master mode
SL to use the device in the slave mode
CS to control the device via a CSEL
See Step 3 for further details.
3
Connecting the E-IDE cable
Two configurations are possible.
The CD-R/RW drive is the only E-IDE device in addition to the hard disk.
Install the jumper in the SL position (Slave).
Connect the 40-pin flat E-IDE cable from the E-IDE port on the mother board,
first to the CD-R/RW drive and then to the ha
You already have an additional E-IDE device installed in your computer.
1. Power cable
2. Master/slave select terminal
3. E-IDE cable
Install the jumper in the MA position (Master).
4. Audio cable
Connect the 40-pin flat E-IDE cable from a second E-IDE port on the mother
board directly to the CD-R/RW drive or first to another additional E-IDE drive
and then to the CD-R/RW drive.
4
Connecting the audio cable from a sound card
Connect the 4-pin audio cable between the sound output terminal on the
CD-R/RW drive and the audio input terminal on the sound card.
For clearer sound,use a digital output terminal.
(Available only for the CAID that supports digital output)
This may not be available for general sound cards.
host interface signal
E-IDE port
Mother board
CD-R/RW Hard disk
(SL) (MA)
r d disk .
Second E-IDE cable
First E-IDE cable
Mother
board
CD-R/RW CD-ROM
Hard disk Hard disk
(MA) (SL)
(SL) (MA)
7