Troubleshooting Guide - Intex SL503 El Manual Del Propietario

5. Screw the Spa LED light onto the Spa tub
upper outlet grid fi tting, hand tighten only
(see Fig 5).
Note: Do not allow water to get inside the
battery compartment, which can damage
the product and void the warranty.
Operation instructions:
• Left button: turns the light ON and OFF, and sets the light in solid color flood mode.
Press left button Once
Color Soft white Green
• Right button: turns the light ON and OFF, and sets the light in changing-color mode.
Press twice to turn off.
• When the light is on, press and hold any button for 3 seconds to turn off the light.
• After 2 hours of continuous use, the device will automatically switch off to save energy.

Troubleshooting guide:

Q. What should I do if the product does not light up?
A. 1. Check the battery holder to ensure 3 AAA batteries are installed correctly with regard to polarity (+ and -).
2. Check that the battery holder and housing cover are snug (hand tightened).
3. Replace the batteries.
Q. What should I do if the light emitted by this product is too weak?
A. 1. Clean outside surface of the light housing using a soft damp cloth. Note: the light housing is an optical component,
to avoid any scratches do not use any hard or abrasive rag to clean it.
2. Replace all batteries with 3 new AAA batteries.
Q. What should I do if the light is flashing rapidly?
A. Replace the batteries.
SAVE THESE INSTRUCTIONS
(309IO) MULTI-COLORED BATTERY OPERATED LED LIGHT FOR INTEX
Twice 3 times 4 times
Teal Blue
Page 3
®
BUBBLE SPA ENGLISH 7.25" X 4.875" 09/19/2017
Upper Outlet Grid
Fig 5
5 times 6 times
Purple OFF
309
IO
Right Button
Left Button