Troubleshooting Guide - Intex CS3220 Manual Del Propietário

TROUBLESHOOTING GUIDE

PROBLEM
• Insufficient operating hours of
INSUFFICIENT
the Saltwater System.
CHLORINE
• The salt level in the pool water
is less than 2000ppm. This is
insufficient.
• Chlorine loss due to intense
sunlight exposure.
• The bather load has increased.
• Clogged or dirty electrolytic cell.
• High UV level exposure.
• Excessive calcium hardness is
wHITE FLAKES IN
present in the pool water.
THE wATER
• No power supply.
NO LED DISPLAY
• RCD has not reseted.
• A power fuse has blown.
• LED failure.
SAVE THESE INSTRUCTIONS
(133IO) SaltwatEr SyStEm ENGlISH 7.5" X 10.3" PaNtONE 295U 07/21/2020
CAUSE SOLUTION
• Increase the daily Saltwater System
operating time. See "Operating Instructions".
• Check the salt level with the Test Kit. Adjust
as needed. See "Salt & Pool water Volumes".
• Use a pool cover when the pool is not
in use and/or when the unit is operating.
• Increase the daily Saltwater System
operating time. See "Operating Instructions".
• Remove the cell for inspection, clean it if
necessary. See "Maintenance".
• Cover the pool with a pool cover for 2
days with the device running and then
test the water using the test strips.
• If the pool is clean and clear, add stabilizer
to the water and then test the water with the
device running.
• Drain about 20 to 25% of the pool
water and add fresh water to decrease
the calcium hardness. Inspect the
electrolytic cell for scale buildup. Clean
the electrolytic cell if necessary.
• Find out the switch and turn on.
• Reset the RCD.
• Contact Intex Service Center.
133
English
A
Page 18