Module Ts4 - Teckentrup TS4 Instrucciones De Mantenimiento

TS4-3 Module

Module TS4-3

(only in connection with TS4-2)
for time-controlled downward travel
LED H1 (green) mains supply
LED H2 (orange) learning
LED H3 (red) fault
S1 programming
button
S2 rotary switch
Coding slit
• Plug module TS4-3 into terminal block X1 of modul TS4-2
(observe position of coding nose).
• Plug module TS4-2 again into terminal block X8
(coding slit according to the marking on circuit board).
Setting of module TS4-2 (only in connection with TS4-3):
• Set rotary switch S2 to desired time (see illustration).
Radio signal
5 min.
4 min.
3 min. 2 min. 1 min.
• Press programming button S1 until orange LED H2
(modul TS4-2) and orange LED H4 (modul TS4-3) are glowing.
Coding nose
3 sec.
10 sec.
20 sec.
30 sec.
40 sec.
50 sec.
LED H4 (orange)
Module TS4-3
X1 terminal block
for module TS4-3
Module TS4-2
Page 11