FGE GG 950 Manual Del Usario página 28

PREPARATION FOR COMMISSIONING (BEFORE START-UP)
Pre-operation checks should be made each time the generator is used. The
engine and mufler will be very hot after the engine has been run. Avoid touching
the engine and muffler while are still hot with any part of your body or clothing
during inspection or repair.
FUEL
Make sure there is sufficient fuel in the tank.
Only use a 2-stroke mixture as fuel. Unleaded petrol mixed with 2-stroke oil according a
Total tank capacity: 4,2 L
ratio of 50:1 (2%).
Fuel mixing procedure
Prepare the quantity of petrol that you want to add and pour it into the fuel tank
1-
Then use the fuel tank cap to measure the specified quantity of oil. Add it into the
2-
fuel tank
Shake the fuel tank to mix the oil and the tank, before starting the motor.
3-
If you do not use oil, the motor will overheat.
-Petrol is a highly flammable and toxic substance.
-Do not fill over the top of the fuel filter, to prevent the fuel from overflowing
when it heats up and expands.
Wipe any drips of fuel immediately
-
-after refueling, make sure the tank cap is tightened securely.
818015-Manuel-A 28
INSTRUCTIONS FOR USE
.
© FAR GROUP EUROPE
EN
.
24/06/08 10:17:52