FGE GG 950 Manual Del Usario página 31

EN
GENERATOR SET OVERLOAD
Never exceed the rated power capacity (Amperes and/or Watts) during continuous ope-
ration. Before connecting and running the generator set, calculate the electrical power
consumption of the electrical equipment (in Watts or Amperes). This electrical power (in
Watts and/or Amperes) is generally found on the identification plate of bulbs, electrical ap-
pliances, motors, etc. The total of all the powers of the equipment used should not exceed
at any one time the rated power of your generator set
Note: an electrical appliance (compass saw, drill, etc.) consumes more Watts or Amperes
than the number specified on the identification plate when the motor is subjected to difficult
use. For example, a saw that is to cut an extremely hard material consumes 3 to 4 times
more Watts or Amperes than the number specified on its identification plate.
STARTING UP, OPERATING AND SHUTTING DOWN THE GENERATOR SET
Starting of the power generating unit :
1- Turn the fuel cock lever to the «on» position
2- Turn the engine switch to the «on» position
3- Turn the choke lever to the position
N.B : The choke is not required to start a warm engine.
4- Pull slowly on the recoil starter until its engaged, then pull it brisky.
5- Warm up the engine.
6-Turn the choke lever back to the operating position.
Before starting the engine, do not connect the electric apparatus.
N.B : «-»means below. .
Aplication wattage indicate when each apparatus is used by itself.
© FAR GROUP EUROPE
818015-Manuel-A 31 24/06/08 10:17:54