Force, Speed And Slowdown Adjustment; Checking The Correct Connection; Mains-Power Supply Unit Connection; Power Supply Unit-Control Unit Connection - Master WiSlide 500 KG Manual De Uso E Instalación

8.2.

FORCE, SPEED AND SLOWDOWN adjustment

The driving force, motor speed and slowdown can be adjusted using the selector switches
installed on the electronic board.
Min. FORCE
LOCK
Emergency
stop force
adjustment
8.3.

Checking the correct connection

LED L1 indicates the correct connection of the electronic control unit. This light flashes every
second and indicates that the connections have been made correctly and that the board is
waiting for commands.
Normally, the red LEDs on the STOP-PHOTO- OLS-CLS inputs are lit.
Normally, the green LEDs on the START-CLOSE control inputs are off.
8.4.

Mains-power supply unit connection

Connect the 220 Vac mains power supply to terminals 1 (L) and 2 (N) of the power supply unit.
8.5.

Power supply unit-control unit connection

The control unit is powered by 24Vdc.
The kit comes with the connection already made.
Power Supply
Voltage
N.B.: If this connection is reversed, there will be no change in operation.
Page 14
Min. SPD.
Max. FORCE
HIGH
SPEED
Motor speed
adjustment
Max. SPD. Max. Sld.
LOW
SPEED
Slowdown
adjustment
Min. Sld.