Symmons SLW-6710-1.5 Manual De Funcionamiento Y Mantenimiento página 3

Installation
1) Seat flange (V2) into sink. Install
gasket (V4), washer (V5) and nut (V6)
onto flange from below sink, but do
not secure nut. Screw on tail piece (V7)
and hand tighten.
1
PLUMBER
PUTTY
OPTIONAL
2
2
V4
V6
3
2) Turn tail piece (V7) and flange (V2)
so rod inlet is facing toward faucet.
Pull assembly down into drain hole.
Secure hardware from below sink.
Install stopper (V1) in the removable
or non-removable position.
3
V1
V2
2
ROD INLET
V7
1
3) Attach inner washer (V8), pivot
rod (V9) and outer washer (V10) to
tail piece (V7). Hand tighten rod
nut (V11) to secure pivot rod (V9).
V2
V3
4) Insert valve bodies (N) through sink
holes.
V5
V7
5) Install washer (R) and mounting
nut (S) to valve body (N). Secure
with screws (U).
V10
V8
V11
V9
V7
N
N
1
R
S
U
3
6) Insert spout body (D) through sink
hole. Attach rubber washer (L)
and metal washer (M) to threaded
rod on spout body. Secure with
mounting nut (O).
D
1
L
M
2
7) Connect lift rod (A) to clevis strap (V13)
and secure with thumb screw (V14).
1
V13
3
O
A
V14