Alemite 596-A Guía De Servicio página 8

SER 596-A (Original Instructions)
CAUTION
Do not expose the Charger to rain, snow, or
frost.
Make sure the cord is located so that it will
not be stepped on, tripped over, or otherwise
subjected to damage or stress.
Do not operate the Charger with damaged
cord or plug. Replace immediately.
Do not operate the Charger if it has received
a sharp blow, been dropped, or otherwise
damaged in any way.
Do not disassemble the Charger.
The Charger is designed to operate on
standard household electrical power. Do not
attempt to use it on any other voltage.
Consecutive charging may cause overheating.
If you need to recharge the Battery
consecutively, wait for about 15 minutes to
allow the Charger to cool.
Do not insert foreign material into the slot for
the Battery in the Charger stand.
Do not disassemble the Battery.
Do not store the gun and Battery assembly in
locations where the temperature may reach or
exceed 104°F (40°C).
Do not short-circuit the Battery.
Do not place the Charger in an area of
extreme heat or cold. It works best at normal
room temperature.
Revision (7-14)
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
Battery Charger Operation
Charge the Battery only with the Charger provided or
optional mobile charger 343289. Make sure power circuit
voltage is same as that shown on the charger specifications
plate. Ensure the Battery properly engages with the charger's
contacts.
Function of Red and Green Lights
When the charger is powered on, the Green light will flash
one time.
Green Light Flashing
Charging.
Green Light On
Battery is fully charged.
Red Light Flashing at 4HZ
Bad Battery condition. The Charger has the ability
to detect a weak or damaged battery. If this LED
function occurs, do not continue to charge the
Battery. Return it to a service center or a collection
site for recycling.
Red Light Flashing at 1HZ/5HZ
Hot/Cold Battery. When the Charger detects that
a Battery is excessively hot or cold, charging is
suspended until the Battery has normalized. Once
battery is at a temperature between to 40° F (4°
C) and 104° F (40° C), the charger automatically
switches to Charging mode. Battery overheating
could be attributed to:
The Battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
Leaving the Battery in the Charger
The Battery can be left connected in the Charger with
the green LED glowing indefinitely. The Charger will keep
the Battery fresh and fully charged. The Charger features
an automatic tune-up mode which equals or balances the
individual cells within the Battery to enable it to function
at peak capacity. Batteries should be tuned-up weekly or
whenever the Battery no longer delivers the same amount of
work. To use the automatic tune-up mode, place the Battery in
the Charger for a minimum of 8 hours.
Changes Since Last Printing
Added CE Compliance
8
Cordless Grease Gun
A. Long continuous running
B. Hot ambient temperature
C. One or more cells are damaged
Alemite LLC