Gladiator GAWB04HWEG Instrucciones De Ensamblaje página 6

3. Attach leg assemblies
Attach the leg assemblies (P1) to the workbench top (P4)
using eight of the provided 3/8" (9.5 mm) x 1
screws (F16). Make sure the screws are inserted straight into
the holes. Loosely install the screws using a 9/16" socket
wrench. Do not tighten the screws completely.
NOTES:
Tightening the screws at an angle can place excessive
■
stress on the screws, which may cause the screws to fail.
The holes in the legs are oval to allow space for minor
■
adjustments as the workbench is assembled.
5. Attach back panel to workbench top
Attach the back panel (P3) to the workbench top (P4) using
the remaining screws*. Make sure that the screws are inserted
straight into the holes. Tighten the screws using a 9/16"
socket wrench.
NOTE: Tightening the screws (F16) at an angle can place
excessive stress on the screws, which may cause the screws
to fail.
*NOTE:
For 4' workbench, use two screws (F16).
For 6' workbench, use three screws (F16).
For 8' workbench, use six screws (F16).
6
Using a 5 mm wrench, attach the back panel (P3) to the leg
/ " (3.81 cm) assemblies (P1) with the four provided M8 hex-head bolts
1
2
(F14). Do not tighten the bolts completely.
Using a 5 mm wrench, tighten the bolts to attach the back
panel (P3) to the outer leg assemblies (P1) completely.
NOTE: Do not overtighten the bolts and screws.
4. Attach back panel to leg assemblies
6. Tighten leg assembly bolts