Insignia IS-LM100761 Guia Del Usuario página 12

IS-LM100761_combo.fm Page 10 Tuesday, April 19, 2005 8:51 AM
Federal Communications Commission Radio
Frequency Interference Statement
This monitor has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This monitor generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this monitor does cause harmful interference to radio or
television reception, which can be determined by turning the monitor off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the monitor and receiver.
• Connect the monitor to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio or TV technician for help.
FCC W
ARNING
To assure a continued FCC compliance, a user must use a grounded power
supply cord and the provided shielded video interface cable with bonded
ferrite cores. Also, any unauthorized changes or modifications to this monitor
would void the user's authority to operate this device.
Note: If necessary, shielded interface cables and AC power cord must be
used to meet the emission level limits.
EMI C
ERTIFICATION
The Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulation.
Cet appareil numerique de class B respecte toutes les exigences du
Reglement sur le materiel brouilleur du Canada.
TCO99
Congratulations!
You have just purchased a TCO'99 approved and labeled product! Your
choice has provided you with a product developed for professional use. Your
purchase has also contributed to reducing the burden on the environment
and also to the further development of environmentally adapted electronics
products.
W
HY DO WE HAVE ENVIRONMENTALLY LABELED COMPUTERS
In many countries, environmental labeling has become an established
method for encouraging the adaptation of goods and services to the
environment. The main problem, as far as computers and other electronics
equipment are concerned, is that environmentally harmful substances are
used both in the products and during their manufacture. Since it is not so far
possible to satisfactorily recycle the majority of electronics equipment, most
of these potentially damaging substances sooner or later enter nature.
10
www.insignia-products.com
IS-LM100761 15-inch Monitor
?