Black 1-9/16" Flat Head Screw; Hidden Cam - Sauder Jaclyn Smith 416404 Manual Del Usuario

Step 10
1
The tabs should insert freely into the
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D30
I
Groove
Insert the DRAWER SIDES (D30 and D31) at
å
an angle into the slot at each end of the RIGHT
DRAWER FRONT (I).
3
Minimum
190 degrees
M
Surface with
I

HIDDEN CAM

Fasten the DRAWER BRACE (M) to the RIGHT
å
DRAWER FRONT (I). Tighten one HIDDEN CAM.
Page 14
D31
Maximum
Arrow
210 degrees
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
D30
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D733) into the grooves in
å
the DRAWER SIDES (D30 and D31) and RIGHT
DRAWER FRONT (I).
4
D30
M
Fasten the DRAWER BACK (D68) to the DRAWER SIDES (D30
å
and D31) and DRAWER BRACE (M). Use five BLACK 1-9/16" FLAT
HEAD SCREWS. (30S). Repeat this step for the other DRAWERS
using the remaining RIGHT DRAWER FRONTS (I) and LEFT
DRAWER FRONTS (J).
416404
D733
U N
F I N
I S H
E D
I
D31
Start each screw a few turns before
completely tightening any of them.
30S

BLACK 1-9/16" FLAT HEAD SCREW

(30 used in this step)
D68
D31
www.sauder.com/services