Extension Rail - Sauder Jaclyn Smith 416404 Manual Del Usuario

Step 3
Separate the EXTENSION SLIDES (O) from the
å
EXTENSION RAILS (N) as shown in the lower diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (N) to the ENDS (A and B)
å
and UPRIGHT (C). Use twenty-four GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
N
Open end
GOLD 5/16" FLAT HEAD SCREW
(24 used in this step)
Push the release lever in and pull the SLIDE from the RAIL.
O
www.sauder.com/services
N
N
Finished edge
Finished edge
3S
N
B
N
N
Open end
N
416404
Open end
N
N
A
N
C N
N
N
Finished edge
Page 7