Information To The User - Shure MVi Guia Del Usuario

Specifications
MFi Certified
Yes
DSP Modes (Presets)
Speech/Singing/Acoustic/Loud/Flat
Input
Combination XLR and 6.35 mm (1/4") TRS
Input Impedance
1/4 inch instrument input>1 MΩ
Bit Depth
16-bit/24-bit
Sampling Rate
44.1/48 kHz
Frequency Response
20 Hz to 20,000 Hz [1]
Adjustable Gain Range
3-pin XLR
6.35 mm (1/4") TRS
Maximum Input Level
3-pin XLR
6.35 mm (1/4") TRS
Headphone Output
3.5 mm (1/8")
Power Requirements
Powered through USB or Lightning connector
Phantom Power
+48V USB/+12V iOS
Mute Switch Attenuation
Yes
Housing
all metal construction
Net Weight
310.0 g (10.93oz.)
Dimensions
42 x 84 x 72 mm H x W x D
Cable
1 m USB cable, 1 m Lightning cable
[1]At Minimum Gain, Flat Mode
0 to +36 dB
+9 dB
0 dBV [1]
+9 dBV [1]
Certifications

Information to the user

This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/
NMB-3(B)
Note: Testing is based on the use of supplied and recommended cable
types. The use of other than shielded (screened) cable types may de-
grade EMC performance.
This product meets the Essential Requirements of all relevant European
directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.
com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de
"Made for iPod," "Made for iPhone," and "Made for iPad" mean that an
electronic accessory has been designed to connect specifically to iPod,
iPhone, or iPad, respectively, and has been certified by the developer
to meet Apple performance standards. Apple is not responsible for the
operation of this device or its compliance with safety and regulatory
standards. Please note that the use of this accessory with iPod, iPhone,
or iPad may affect wireless performance.
iPad, iPhone, iPod, iPod classic, iPod nano, iPod touch, and Retina are
trademarks of Apple Inc., registered in the U.S. and other countries.
iPad Air and iPad mini are trademarks of Apple Inc. The trademark "iP-
hone" is used with a license from Aiphone K.K.
Mac and Lightning are registered trademarks of Apple Inc.
® ®
7