Prodipe ST1 Manual De Usuario página 8

Dear Customer,
We would like to thank you for the confidence you have placed in us by purchasing a Prodipe
product
ST1 is a professional condenser microphone for recording which adopts advanced SMT,
precision control circuit with Pressure Gradient Transducer cartridge and a large vapor-
deposited gold diaphragm to achieve high sensitivity, extended frequency response, no
crossover distortion and low self noise.
The Zinc-die casting housing is spray printed. Its standard XLR (F) connector matches all
kinds of audio equipment.
ST1 is tailored for broadcasting, television studios, recording studios, stage performances,
etc.
Usage:
1.Turn on your amplifier or mixing board and set the volume control to minimum position,
To connect the phantom power to the microphone turning on the phantom switch,
accommodate the volume control from low to high so obtained effect to your moderate
level for protected the sauna from pounding.
2. If the head of the microphone is covered by hand or brought close to the speaker, a
howling sound may be generated. To prevent this, first decrease the volume, then place
the microphone so that it is not pointed to the speaker and that there is a sufficient
distance between the microphone and speaker.
3. The sensitivity of cartridge is very fine, Don't do drop. Hit it or apply strong shock to it.
4. To maintain the sensitivity and quality of sound reproducing, avoid exposing it to
moisture and extreme temperatures.
5. The related specification or deployment are subject to change without any prior notice.
Specification:
Element: Pressure Gradient Transducer
Polar Pattern: Uni-directional
Frequency Response: 20Hz-20kHz
Sensitivity: -35dB±2dB (0dB=1V/Pa at 1kHz)
Output Impedance: 100Ω±30% (at 1kHz)
Load Impedance: ≥1000Ω
Self Noise: 15dB A (IEC 581-5)
Max. Input SPL: 130dB (at 1kHz≤1% T.H.D)
S/N Ratio: 79dB
Low Frequency Attenuation: 100Hz/oct 10dB
Phantom Power Requirement: 48V DC
Copyright © 2010 IPE Music