3
Cycle Selector
Dry Level
4
Selection Button
DVDV476_484_03022E-03_EN.indd Sec6:25
DVDV476_484_03022E-03_EN.indd Sec6:25
To select a cycle, rotate the Cycle Selector dial to the desired cycle.
The indicator light by the cycle name will illuminate. The Nomal, Heavy Duty,
Perm Press, Bedding, Towels, Delicates, Wool cycles are Sensor Dry cycles.
Sensor Dry automatically senses the moisture in the load and shuts the dryer
off when the load reaches the dryness level you have selected with the Dry
Level Selection Button (see below).
Normal – Use this cycle to dry loads of cotton, underwear, and linen.
Heavy Duty – Use this cycle to dry heavy fabrics such as jeans, corduroys, or
work clothes with high temperature heat.
Perm Press – Dry wrinkle-free cottons, synthetic fabrics, knits, and
permanent press fabrics automatically.
Bedding – For bulky items such as blankets, sheets and comforters.
Towels - To dry bath towels and similar items.
Delicates – The Delicates cycle is designed to dry heat-sensitive items at a
low drying temperature.
Wool – For machine washable and tumble dryable wool only.
Sanitize – Sanitizes garments by infusing high temperature heat deep into
the fabric during the drying cycle. Use this course to keep your bedding and
curtains clean through sanitization.
Time Dry – Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry, then press the Adjust Time up arrow
to set the drying time. Press the arrow repeatedly to scroll through the time
settings.
Quick Dry - Provides a 30 minute drying cycle.
Air Fluff – The Air Fluff cycle tumbles the load at room temperature air.
Refresh – Use to smooth out wrinkles and reduce odors in loads of one to
four items. In this cycle a small amount of water is sprayed into the dryer
drum after several minutes of tumbling with heat.
Wrinkle Away – Reduce wrinkles in dry clothes that have been left in a
closet for a while by providing advanced wrinkle release performance through
optimized steam care. Reduced wrinkles in up to 3 items at a time.
You can change the drying time using the Adjust Time button.
-
You can increase or decrease the cycle time, but you cannot select a time
lower than the lowest pre-set automatic drying time (20 minutes).
You can set the drying time to 20 30 25 33 in this order.
-
If you overload the dryer, you will get less than optimal results.
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles,
press the Dry Level button. An indicator light will illuminate next to the dryness
level you selected.
Press the button repeatedly to scroll through the settings. Larger or bulkier
loads may require the Very Dry or More Dry setting for complete dryness.
The Less Dry setting is best suited for lightweight fabrics or for leaving some
moisture in the clothing at the end of the cycle. Damp Dry is designed to
partially dry items. Use for items that lay flat or hang to dry.
operating instructions, tips _25
2013-06-28
2013-06-28
7:24:34
7:24:34