Connecting The Antenna And The Receiver - Kathrein BZD 40 Manual De Usuario

Installation, Connection and Setup
F standard
connector
Figure 5

Connecting the Antenna and the Receiver

16
• Before fi tting the F standard connector, make sure no strands of the
braided shield are touching the inner conductor. This could cause a
short-circuit. Carefully twist the F standard connector onto the end of
the cable until it is fi rmly in place. The inner conductor should protrude
a maximum of 2 mm out of the connector. The inner conductor must
not be bent! (fi gure 5)
The quality of the received signal also depends on the cable
assembly!
1. Connect the antenna to the DVB-T receiver by the coaxial cable
provided. You can install the antenna regardless of the polarisation
of the transmitted signals.
• Screw the F standard connector onto the matching antenna
socket. Push the cap over the F standard connector until it locks
into the antenna housing.
• Plug the IEC connector on the rear of the receiver into the opening
provided for it.
2. Connect the receiver to the TV set (consult the receiver manual for
more details) and switch the receiver on. Set the TV to AV mode, if
it does not do so automatically when you switch on the receiver.
3. Check the DVB-T receiver's Setup menu to make sure the power
supply to the antenna is connected via the coaxial cable.
4. It should now be possible to receive DVB-T programmes.