Maintenance; Environment Protection - Truper SOPLA-600 Manual De Usuario / Instructivo De Usuario

Cleaning
• Clean the blower after each use. It will be kept in good
conditions and will lengthen its useful life.
• To clean, Use a piece of cloth with warm water and a
soft brush.
• After each use, disassemble all the parts from the tool
are remove all the particles. Pay special attention to the
inner ventilator driver.
• Clean perfectly the blower ventilation to free them from
any obstruction.
Storage
• Clean the tool before storing to prevent mildew.
• Store the blower in a dry and lukewarm place, away
from sun light (preferably dark) and away from the reach
of children.
• Avoid storing the blower in plastic bags, otherwise the
humidity generated could damage it.
• Keep the tool away from corrosive agents like chemical
substances and anti-freeze salts..
8
ENGLISH

Maintenance

Carbon Brush Replacement
• It is necessary to replace worn carbon brushes (burnt,
broken or smaller than 0.19" long) with new carbon
brushes.
• When replacing carbon brushes always replace both.
• Remove the worn carbon brushes from the carbon
brush holder and remove with compressed air the dust
accumulated.
• Set the new carbon brushes reversing the order. The
carbon brushes should fall in the carbon brush holder
easily.
• After setting the new carbon brushes, allow the tool to
run unloaded a couple of minutes to better adjusting the
carbon brushes.
• Use only
designed specifically with the hardness and electric
resistance adequate for each type of motor. Carbon
brushes that are out of specification may damage the
motor.
Maintenance
• Any type of repairs or maintenance shall be carried out
in a Authorized Service Center.

Environment Protection

• After the machine is worm out, the materials such as
packaging, damaged parts or the tool shall not be
handled like garbage. Take those materials to a recycling
facility to be trated according to the environment
standards.
spare carbon brushes