Publicidad
Idiomas disponibles
Idiomas disponibles
PAG 13
3. If your VCR has only one set of A/V output jacks and you want to use it with a nearby TV, connect 75ohm RF coaxial
cable from the modulator signal OUT port on your VCR to the RF IN port on your TV.
Note: In order to also view cable programs on that TV, connect your incoming cable TV source to the IN port of the VCR.)
4. Locate and orient the transmitter according to the section of this manual titled "Orienting Units for Optimum Perfor-
mance" for best performance of transmitter.
HOW TO TRANSMIT AUDIO/VIDEO FROM YOUR SATELLITE RECEIVER. (PAG 3).
You can transmit audio/video either directly from your satellite receiver, or by connecting them to your VCR. To transmit
directly from your satellite receiver, follow the instructions below.
1. Connect one set of audio/video (A/V) cables (RCA or SCART cable) to the A/V jacks of the transmitter and to the audio/
video OUT jacks (RCA or SCART connector) of the satellite receiver or laser disc player.
2. Plug one end of the power adapter into the back of the transmitter and the other end into any 230-volt wall outlet (or
120-volt). Use only the adapter provided.
3. If your satellite receiver or laser disc player has only one set of A/V output (RCA or SCART connector) jacks, in this
case, please connect 75ohm RF coaxial cable from satellite receiver's modulator output port to TV RF input terminal.
4. Locate and orient the transmitter according to the section of this manual titled "Orienting Units for Optimum Perfor-
mance" for best performance of transmitter.
HOW TO RECEIVE WIRELESS AUDIO/VIDEO SIGNALS ON YOUR TV.
There are two ways to receiver wireless audio/video signals on your remote TV (TV in another location such as in bedro-
om, kitchen).
1. Connect the receiver directly to the remote TV.
2. Connect the receiver to a VCR, which is then connected to the TV.
If your TV has picture-in-picture capabilities, you can view any image transmitted by sender, such as your sleeping baby,
in a small inset picture while enjoying other programming on the rest of the screen. Consult the owner's manual of your
TV for instructions on using these capabilities.
CONNECTING RECEIVER DIRECTLY TO REMOTE TV. (PAG 3).
If your TV has A/V jacks, connect one set of A/V cables (RCA or SCART cable) to the TV's A/V jacks and to the A/V output
jacks on the receiver.
If the TV has only a single jack for audio input, connect the white plug to that jack.
CONNECTING RECEIVER TO REMOTE TV THROUGH VCR. (PAG 4).
This setup enables you to record transmitted audio and video on your remote VCR and also enjoy the picture and sound
on a remote TV at the same time.
1. Connect one set of audio/video (A/V) cables to the A/V output jacks of the receiver and to the A/V input jacks on your VCR.
2. If your TV has A/V input jacks, connect another set of A/V cables to the TV's A/V input jacks and to the A/V output jacks
on your VCR.
3. If your TV does not have any A/V input jacks, please connect a 75ohm coaxial cable from the TV's antenna in (or RF in)
to VCR's modulator output.
This feature is optional
4. Plug one end of the sender power adapter into the back of the receiver and the other end into any 230-volt (or 120
volt) wall outlet. Use only the adapter provided.
5. Locate and orient the receiver to best video and sound quality please according to the section of this manual titled.
Publicidad
