Monster MST3304BK Manual Del Propietário página 3

ASSEMBLY INSTRUCTIONS
Step 1: Assembly Preparation
Remove all contents from box. Reference the parts list
to make sure you have all the parts.
CAUTION
Verify your workbench can support 150 lbs. (68 kg.).
Failure to follow this warning could result in damage to
property or personal injury.
NOTE
Cover workbench to prevent any damage to surface.
Step 2: Pry Bar Holders
Lay two legs down on the table top and attach pry bar
holder as shown in figure 2. Repeat with other two legs
and pry bar holder. NOTE: Legs are marked with UP
label to indicate which side is up.
Step 3: Attaching Casters
Turn bottom tray upside down. Align holes in locking
and non-locking casters with matching holes in the
bottom tray as shown in figure 3a. Attach using M8
Hex bolts, lock washers and nuts from caster bolt kit
and hand tighten.
NOTE
Ensure that both locking casters are on
same end of the cart. We suggest same side as handle.
NOTE
Before moving to step 4 place a covering
on the floor (to protect the cart) and finish assembly
on the floor.
Step 4: Aligning the Legs
Make sure the drawer assembly lid is open. Place legs
and attached pry bar holders onto drawer assembly and
bottom of tray as shown in figure 4. Repeat on opposite
side of service cart. Hand tighten so all holes will line up.
4.
A
B
MST3304BK/MST3304G
2.
3.
3a.
3
A
B
rev. 10/03/18