Monster MST3304BK Manual Del Propietário página 4

ASSEMBLY INSTRUCTIONS
Step 5: Attaching Bottom Tray and Drawer
Assembly to Legs and Bumpers
Align holes in legs and bumpers with matching holes
in bottom tray and drawer assembly as shown in figure
5. Insert bolts through legs and bumpers and into
bottom tray and/or drawer assembly and secure from
the inside with leg washers and nuts until all side holes
have been attached and hand tightened.
Step 6: Attaching the Handle
(A) Align the other legs and bumpers with the front
corners of the bottom tray and drawer assembly. Align
the hole on the handle with the second hole down on
the drawer assembly and (unattached) leg as shown in
figure 6. Insert M8 x 19 handle bolts through handle,
through the legs and bumpers, and into the drawer
assembly as shown in figure 6. Secure with washer
and nut from handle bolt kit and hand tighten.
(B) Attach remaining M8 x 17 bolts (on the opposite
side from push handle) directly into legs.
Step 7: Securing Legs and Bumpers
Using two people, turn the cart upright. Continue to
bolt through aligned holes in the front and back of
the cart with the M8 x 17 bolts, washers, and nuts as
shown in figure 7. Hand tighten. ALL holes should now
be aligned and secured.
Step 8: Tightening Bolts (not shown)
Use a 13mm wrench or a ratchet with 13mm socket
or adjustable wrench to tighten all bolts. Be sure to
apply pressure to bolt head while tightening to keep in
correct position. Once all bolts are tightened, your cart
is complete. See page 5 for parts breakdown.
MST3304BK/MST3304G
5.
6.
7.
4 rev. 10/03/18