Video Stream Parameters Settings - Urmet 1093/900 Guía Rápida De Configuración

5.3

VIDEO STREAM PARAMETERS SETTINGS

The NVR manages three different video streams for each camera associated to one of its channels:
Main stream: max. resolution stream, used for video-recording on hard disk and displaying on local network
Sub stream: medium/high resolution stream, for remote displaying
Mobile stream: low resolution stream, for remote displaying
To configure each stream open the OSD menu page [Network] and select the stream to be configured:
1. In Main stream menu page select [Default] and check that the factory default parameters are set.
Select [Copy] to copy the same parameters to all the channels and click on [Save] to save parameters in the cameras.
2. In Sub stream menu page select [Default] and check that the factory default parameters are set.
Select [Copy] to copy the same parameters to all the channels and click on [Save] to save parameters in the cameras.
3. In Mobile stream menu page select [Default] and check that the factory default parameters are set.
Select [Copy] to copy the same parameters to all the channels and click on [Save] to save parameters in the cameras.
IMPORTANT NOTE: these factory settings are the suggested ones for video streams in order to obtain the right balance
between video quality and fluidity, in locally and remotely recording and LIVE displaying.
However, it is possible to manually set stream parameters different from the factory ones described above.
DS1093-154A 31