GPO Winchester Manual De Usuario página 15

FM Mode Operation
1. Press "Function" button and switch into FM mode.
2. To scan stations manually, rotate "Tune +/- " knob to adjust stations
by 0.05MHZ until you get your favorite stations.
3. To auto scan stations, press " Scan" button to search stations , if
station signal is available, scan will stop automatically and the radio
will play this station. Press "Scan" button, it will activate a full station
search. A progressive bar will show the progress of the scan and the
number of stations found during the scan. The stations scanned will
be stored automatically when the scan is complete.
4. You can rotate " Tune +/- " to switch among stations stored.
5. Rotate "Volume +/-" to adjust the volume.
6. To store a station preset , you must first tune to the station you wish
to set as a preset. Then press "Preset" button to activate store function.
Rotate "Tune " to scroll through the numbered preset locations (1-30),
press and hold "Select" button to store the station. "Preset x Stored" will
be shown on the screen. 30 stations can be stored in total. To tune to a
preset FM station, press "Preset" button, use "Tune " to scroll through the
preset stations. Press "Select" button or wait a few seconds to confirm when
you see the station you would like to listen. The radio will begin to play. If
you have already saved a station in that preset position , the new selection
will override the previous saved station.
7. In FM mode, press "INFO" button to display the information such as
RDS, audio type, station frequency, time and date, signal quality,
program text, program type.
GPO_Winchester_user_Manual EU - Jan 2020 v2.indd 15
15
26/12/2019 15:59