Connecting A Computer; Using Your Tv; Turning Your Tv On And Off; Selecting The Tv Signal Source - Insignia NS-LCD47HD-09 Guia Del Usuario

Connecting a computer

Warning
Make sure that you turn off and unplug your TV
before installing devices.
Note
Many newer computers have HDMI output.
To connect a computer using VGA:
1 Plug a VGA cable from your computer into
the VGA jack on the back of your TV.
2 Plug an audio cable from your computer's
audio out jack into the AUDIO jack on the
back of your TV.
3 Plug in and turn on your TV.
4 Press the INPUT button repeatedly to select
the VGA input source.
Note
When the computer goes into standby mode, your
TV turns off. If your TV does not turn on when you
"wake" your computer, press the POWER button
on your TV or remote control.

Using your TV

Turning your TV on and off

To turn your TV on and off:
1 Make sure that the power cord is connected
to your TV and a power outlet.
2 Press the button to turn on your TV. The
power indicator LED turns blue.
3 Press the button again to return your TV
to standby. The power indicator LED turns
red.
10

Selecting the TV signal source

Setting up the channel list

Automatically setting up channels
VGA cable
Manually adding or deleting channels from the
channel list
www.insignia-products.com
Insignia NS-LCD47HD-09 47" LCD HD TV
To select the TV signal source:
• With the TV on, press the INPUT button on
either the TV or the remote to choose from:
• ANT (antenna)
• TV
• Composite rear
• Composite side
• S-Video rear
• S-Video side
• Component 1
• Component 2
• VGA
• HDMI1
• HDMI2
• HDMI3
If you select Video1, press the VIDEO button
to choose between composite and S-Video.
Note
HDMI, the HDMI logo, and High-Definition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing LLC.
After you select your TV source, if you selected
antenna or cable you need to set up the channel
list. When you set up your channel list, your TV
searches for all available channels in your area
and stores a list of these channels. When you
press the CH – or CH + buttons, your TV skips
the channels that do not have a signal.
To automatically set up the channel list:
1 Press the MENU button. The Main on-screen
display menu opens with Setup highlighted.
ENTER
2 Press to enter the sub-menu, then press
or to highlight Auto Ch Search.
3 Press ENTER or to start the search.
Note
You can press the Exit button to stop the search.
After you create a channel list using the Auto Ch
Search option, you can manually add or delete
channels from the channel list.