Conservator GRM183QW Manual De Instalación Y Operación página 11

•¼ inch Socket Wrench
•Adjustable Wrench
1) Unplug refrigerator from wall outlet.
2) Remove ice tray rack from freezer .
3) The frozen shelf moved to the next partition.
4) Remove plugs from inside freezer compartment with putty knife.
5) Peel off label covering ice maker hole.
6) With needle nose pliers, remove foam from hole.
7) Push water inlet tube into small hole on back of refrigerator. Rotate while inserting tube until
flat surface of inlet tube is tight against back of refrigerator.
8) Push plastic water supply tubing (3) into water inlet tube (11) as far as it will go and finger
tighten nylon compression nut onto threaded end of inlet tube. Tighten another one half
turn with a wrench. DO NOT over tighten.
•Needle Nose Pliers or Nut Driver
•Knife
9