Matco Tools MCL1828LED Instrucciones De Operación página 3

3 . Always be sure you have firm footing .
4 . Be sure no one is below when using the light in high locations .
5 . Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact .
Follow material supplier safety data .
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1 . Your new battery pack is not fully charged . You may need to
charge before use .
2 . To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction .
3 . To install a battery align the tool with the battery, place the
front of the tool about halfway up the battery, push forward
until click is heard indicating full installment .
Charging The Battery Pack
1 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source
and stow away in a safe place .
Light Operation
1 . Fully charge the battery pack before use .
2 . To remove the battery pack from the flashlight, press the
button on the front of the battery pack .
3 . Pull the battery forward to separate the battery from the
flashlight .
4 . After charging, insert the battery pack into the flashlight all
the way until it locks into place with a little click .
Head Angle
Pivoting head rotates 270º horizontally and 180º vertically,
which allows the light to be projected in any direction . Adjust
as desired .
MCL1828LED
MCL1828LED 18V LED WORK LIGHT
Replacing Light Panel
1 . Rotate lens cap counterclockwise (see Figure 1) .
2 . Remove light panel from housing .
3 . Disconnect the wires by separating the quick connects .
4 . Connect wires of new light panel using quick connects .
5 . Position new light panel .
6 . Reinstall lens cap and rotate clockwise to tighten .
Replacement light panel available as RSMFL28LP
Replacement lens/ring set available as RSMPFLLR
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
The light panel is very hot after operation . Wait until it cools
WARNING
down before attempting replacement .
Always remove the battery pack from handle before
WARNING
changing the light panel or servicing .
Figure 1
Note:
Battery and charger are NOT included .
3 12/17/13