Priming - Waterco Supatuf ECO 100 Manual De Instalación Y Funcionamiento

• English
• ROTATION OF 3 PHASE PUMP
CLOCKWISE ROTATION

PRIMING

The Waterco Limited pump will prime and re prime providing the hair and lint pot bowl is full of
water and there is sufficient supply from the suction point.
If you lose water from the hair and lint pot bowl it will be necessary to re fill it before starting.
1. Remove the clear lid and fill the hair and lint pot bowl with water.
2. Replace the lid ensuring the o-ring is correctly located and start the pump.
After you have done this allow a few minutes (maximum) for the pump to start delivering water.
WARNING
!
High suction lift or long suction lines will require additional time to prime and can severely affect the
performance of the pump. If the pump will not prime, (flow) repeat step 1 and 2 above.
WARNING
!
Mechanical seals if allowed to run dry can be damaged rapidly and may need to be replaced.
ENSURE that there is always adequate water in the hair and lint pot bowl before you commence start
up.
If you are unable to prime the pump please see the trouble-shooting guide.
Ensure all suction and discharge valves are open before you start the pump, operating the pump with
these valves shut can damage the pump.