Battipav Super Pro Manual De Instrucciones página 13

Battipav srl
Tool:
TuNGsTEN cARBIDE WhEEL
Art. 492
Intended use:
cERAMIcs, sINGLE-FIRED TILEs, GREs,
KLINKER, TERRAcOTTA AND MARBLE
USE
CAUTION
All our tools undergo a series of tests and are
carefully checked before they leave our factory.
BATTIPAV is constantly involved in developing the
equipment we supply. We therefore reserve the
right to make any changes we deem necessary. No
demands may therefore be made on the basis of the
information and illustrations found in this manual.
The SUPER PRO tile cutter is a tool that is
technologically advanced and that offers high
performance. It is suitable for cutting ceramic
materials.
WARNING
The manufacturer accepts no responsibility for
SUPER PRO tile cutters used with other tools, or for
cutting any materials other than those indicated in
the "INTENDED USE" paragraph.
ASSEMBLY
Remove the machine from the packaging and ensure
that no component has been damaged. Proceed by
assembling the SUPER PRO tile cutter according to
the type of use you wish to implement.
RIGHT-HANDED OPERATORS
1
a) Set up the carriage rod unit onto the
worktop.
2
Block the carriage rod unit into place with the
four screws supplied, ensuring that the cutting
wheel remains in the centre of the cutting side,
along its entire length.
b) Then tighten the nuts with the 10 mm
hexagonal spanner.
c) Remove the two M6 nuts from the rod onto
which the tile rests, with the 10 mm hexagonal
spanner (Ref. exploded view Pos. 10 - Art.
30092).
3
d) Place the rod onto which the tile rests on the
front part of the worktop, by inserting the
screws into the respective holes found on the
worktop itself
e) Verify that the cutting tool is set at the 0 cm
position of the rod onto which the tile rests.
4
f) Adjust the rod onto which the tile rests for it to
be perpendicular to the cutting side.
3
g) Then tighten the nuts with the 10 mm
hexagonal spanner.
h) Insert the rod support fence into the relative
housing.
i) Remove the M6 nut from the blocking lever
with the 10 mm hexagonal spanner.
l) Insert the lever into the opening near the rod
support fence housing.
5
m)Bring the blocking lever to rest on the rod
support fence,.
n) Block the lever blocking unit of the rod into
place with the spanners supplied.
CAUTION
THE ROD SUPPORT FENCE IS BLOCKED INTO
PLACE BY TURNING THE LEVER ANTI-CLOCKWISE.
LEFT-HANDED OPERATORS
6
a) Set up the carriage rod unit onto the worktop.
b) Centre the cutting wheel of the carriage as
2
shown in point "a" in the paragraph dedicated
to right-handed operators.
c) Block the carriage rod unit into place with the
four screws supplied.
d) Unscrew the knob that blocks the fence in
place.
7
e) Turn the fence upside down and retighten the
knob back into place.
THE BLOCKING KNOB MUST BE ALIGNED WITH
THE CENTRE OF THE CUTTING SIDE OF THE
WORKTOP BEFORE TIGHTENING IT, IN ORDER TO
OBTAIN A CORRECT 90° POSITION OF THE FENCE.
13
GB