Audiolab FORGE 15A Manual Del Usuario página 4

1. use only the recommended fuse type as indi-
cated in this manual. Do no short-circuit the
fuse holder. Before replaicing the fuse, make
sure that the product is OFF and disconnected
from the AC outlet.
2. Move this Equipment only with a cart, stand,
tripod, or bracket, specified by the manufac-
turer, or sold with the Equipment. When a cart
is used, use caution when moving the cart/
equipment combination to avoid possible inju-
ry from tip-over.
3. Permanent hearing loss may be caused by
expousure to extremely high noise levels. The
US Government´s Occupational Safety and
Health Administration (OSHA) has specified
the permissible exposure to noise level. These
are shown in the following chart:
According to OSHA, an exposure to high SPL in excess of these limits may result in the loss of heat. To
avoid the potential damage of heat, it is recommended that Personnel exposed to equipment capable of
generating high SPL use hearing protection while such equipment is under operation.
The apparatus shall be connected to mains socket outlet with a protective earthing connection.
The mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
*
FORGE 15A are Active Speakers for professional use, they can be used in following electromagnetic environment: residential,
commercial and light industrial, urban outdoors. They are the apparatus Not intended for rack mounting.
*
FORGE 15A, the peak inrush current is 0.9A
*
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not
cause harmful interference, and (2)this device must accept any interference received, including interference that may cause unde-
sired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced
radio/TV technician for help.
P. 4
AUDIOLAB FORGE 15A -
English version
Hours x day SPL
8
6
4
3
2 100
1.5 102
1 105
0.5 110
0.25 or less 115
Example
90 Small gig
92 Train
95 Subway train
High level
desktop
97
monitors
Classic music
concert
Rock concert