Evercraft 776-3759 Instrucciones De Operación página 5

• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres s ure at the gun to operate. Proper air pres s ure for this tool should not exceed 35 PSI for lacquer
and 43 PSI for enamel.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro d uc t ion.
• Clean all parts after use.
HVLP SPRAY GUN
The model you have purchased is a professional high
volume, low pressure spray gun. It is designed to
spray very efficiently with virtually no overspray. To
accomplish this, the inlet pressure regulation is
critical. Please be sure to read pressure requirement
carefully.
In normal use, the nozzle wings are
hor i z on t al as shown here. This pro v ides a
ver t i c al fan-shaped pat t ern which gives
max i m um, even ma t e r i a l coverage as the gun
is moved back and forth par a l l el to the sur f ace
being fin i shed.
776-3759
FOR BEST PERFORMANCE, PLEASE BE SURE TO DO
THE FOL LOW ING BEFORE USING THIS SPRAY GUN
AdjusTmENTs
Air flow adjustment screw
Turn right to decrease flow,
left to increase.
sprAyiNg
Spray pattern may be in f i n ite l y adjusted
from round to flat.
fluid control screw
Turn right to decrease flow,
left to increase.
spray width adjustment screw
Turn right for round, left for fan.
Set inlet pressure at no more than 43 PSI. For op t i m um
per f or m ance, some ma t e r i a ls may spray better at PSI
ratings below 43 PSI. If unsure, always test at PSI ratings before
using on final production. Try spray. If it is too fine, de c rease the air
pres s ure or open fluid control screw. If the spray is too thick, close
the fluid control screw. Reg u l ate the pat t ern width and repeat
ad j ust m ent of spray as needed.
5
Air pressure regulator
Turn right to decrease air pressure,
left to increase.
06/04/12