Installation & Preparation; Attire; Set-Up; Nozzle Review - A&I Products PW-1500E Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
RISK OF EXPLOSION!
DO NOT OPERATE UNIT IN AN
AREA WHERE FLAMMABLE GAS
VAPORS MAY BE PRESENT. AN
ELECTRIC SPARK MAY CAUSE
AN EXPLOSION.
RISK OF BURSTING!
DO NOT STORE / OPERATE UNIT
IN A FREEzING ENVIRONMENT.
WARNING
RISK OF INJECTION CAUSING
SEVERE INJURY!
NEVER LOOK DIRECTLY AT THE
NOzzLE ORIFICE UNLESS IT
IS DISCONNECTED FROM THE
GUN/WAND ASSEMBLY!
WHEN USING THE ADJUSTABLE
NOzzLE, NEVER ADJUST THE
SPRAY PATTERN WHILE THE
TRIGGER GUN IS OPEN!
ADJUSTABLE NOzzLE
LOW PRESSURE / DETERGENT
NOZZLE COVER
HIGH PRESSURE
NOZZLE COVER
0
INSTALLATION & PREPARATION

ATTIRE:

Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin.
respiratory mask) may be required when using detergent cleaning agents with
this washer.

SET-UP:

. This unit should only be placed on a level surface to ensure proper lubrication
for the water pump while operating. NEVER spray water directly on the
unit!
2. Do not place unit in an area:
a. where there is evidence of oil or gas leaks.
b. where flammable gas vapors may be present.
3. Do not allow the unit to be exposed to rain, snow or freezing temperatures.
If any part of the unit becomes frozen; excessive pressure may build up in
the unit which could cause it to burst, resulting in possible serious injury to
the operator or bystanders.
4. Before initial use, replace the oil travel plug with the dipstick provided with
the unit. Be certain the oil level is in the center of the sight glass before
each use. If low, fill with SAE20 or 30 non-detergent pump oil. DO NOT
OVERFILL!

NOzzLE REVIEW:

The Adjustable Spray Pattern Nozzle (with lance) has two functions:
NOTE: Nozzle assembly should NOT be connected to the gun assembly at this
time.
. Selections of high and low pressure can be achieved by pulling the nozzle
cover at the end of the wand "TOWARD" yourself for the High Pressure
setting, and pushing the nozzle cover "AWAY" from yourself for Low Pressure
and detergent application.
2. The spray pattern can be adjusted from 0° to 65° by rotating the nozzle cover
at the end of the wand in a clockwise and counter-clockwise direction. Be
cautious when using the straight narrow stream. It is not recommended
for use on painted or wood surfaces OR items attached with adhesive
backings.
Additional safety attire (such as
Operator's Manual

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido