ITW DUO-FAST HT-755 Classic Manual De Instrucciones De Operacion Y Seguridad página 14

Cannister Load Design:
1) Hold the tool upright and disconnect the air supply.
2) Unlatch feed pawl access gate and swing magazine cover open.
3) Remove adhesive strip from the nails and place the coil into
the magazine. Feed the nails over the feed pawls until the first
nail is in the driver blade raceway.
4) Close the magazine cover and then the gate making sure gate
is latched securely.
5) Hold the tool upright and connect the air supply.
14