Tabla de contenido
Publicidad
Instruction Manual
11600
Preparation
1. Inspect all components for debris, obstructions, and/or damage
prior to installation.
2. Cut the PEX tubing to length, ensuring a square cut - an irregular
cut may result in a failed connection. For larger diameter PEX an
ABS cutter is recommended.
Pure
Pure
3. Slide the stainless steel sleeve over the tubing until it is properly
seated.
" to 1
" Press Instructions; Auto Press
1
1
2
2
Never press with empty jaws as this will damage the jaws.
Regularly check tool jaws and sleeve for any abnormalities that could be an indication of a damaged tool.
Never re-use stainless steel press sleeves.
1. Open the jaws
(squeeze at the
points indicated
in the diagram)
and position
squarely around
the sleeve, then
allow the jaws
to firmly grasp
the sleeve.
2. Squeeze the
trigger until
the press is
complete.
3. Open the jaws
and remove
the tool from
the sleeve.
HE.16527_D © 08/2015
®
Link Plus
Link
®
Link Plus
Link
®
Pure
Link
Link Plus
®
Pure
Link Plus
Link
Heat
Link
Heat
Link
Heat
Link
4. Push the tubing and sleeve onto the fitting or Multiport tee until
it bottoms out on the shoulder.
5. Use the sight hole in the sleeve to verify proper seating of PEX
tubing.
6. Make press as instructions below for
page for 2".
4. Inspect the connection to ensure the tubing is still properly
seated (only PEX is visible in sleeve sight hole), and the press
has been properly formed onto the sleeve (see diagram for
guideline).
®
Tool jaws imprint "HL" on the sleeve.
An improperly positioned tool may result in a poor press and a
damaged fitting.
Sight
Hole
®
®
®
Pure
Link Plus
Link
®
Pure
Link Plus
Link
" to 1
" and on the next
1
1
2
2
Improperly
PEX
positioned
improperly
jaws
seated in
sleeve
IV
Publicidad
Tabla de contenido
