OHAUS DFL600WR Manual De Instrucciones página 9

Defender Series Floor Scale
3. Lift the weighing platform and buckle the safety buckle to prevent the
scale from falling. Check the location of the eight expansion bolt holes on
the bottom frame of the scale body and the mounting feet at this time,
and install the expansion bolts to the ground (note: the expansion body
must be installed before closing the scale body, otherwise the bottom
frame will be deformed).
4. Release the safety buckle and close the scale body. Adjust the height of
the sensor connector to ensure that the connector is stable on the
ground, and at the same time screw the knob to the end.
5. Connect the signal cable and the instrument.
Figure3-2：Expansion bolt hole location
Figure3-3： Rotation position of Knob
EN-7