Technical Specifications - SEA FOTO 50 Guia Del Usuario

2 - TECHNICAL SPECIFICATIONS

Range:
Frequency infrared:
Electrical imput:
Relay contacts:
Operation:
Box material:
Fittings:
Operating temperature:
Dimensions:
Power Supply
12V, 24V c.c./~
2.1 TERMINAL BOARD DIAGRAM (see Fig. 1)
3 - INSTALLATION AND ALLIGNMENT
3.1
Wall or fasten the nylon bowes, after having
extracted the optical/electronic circuits, by
removing the circuit part (four screws) (see Fig. 2).
The boxes are to be installed on the same axis
and at the same height from the ground (see Fig.
3).
Prepare the connecting cables (0,5 sq.mm max
3.2
flexible) going to the boxes by connecting them to
the respective extraactable terminal boards of the
receiver and transmitter (cables must be as short
as possible) (see Fig. 1).
Insert the optical/electronic parts into the box and
3.3
make it slide towards the bottom, so that the cover
can perfectly match (if it cannot match well, the
connectiong cables might be too long).
3.4 Fasten the optical/electronic part to the box with
the four proper screws placed on the cover.
35m nominal. This value
can decrease to 70%
owing to very violent
atmospheric
phenomena or
to inaccurate
allignement.
1000Hz
receiver 25mA
trasmitter 30mA
1A max - 24V
(max 50W - 220v)
normally energized
relay
fiber glass added nylon
cunterbracket to be
welded, metal box for
wall embedding, column
from -20°C
75x75mm (endosable
part: 65 mm dia)
Power Supply
24V c.c./~
to +60°C