Tabla de contenido
Publicidad
6. Make sure that your equipment is stable on the workstation before you move the
Workstation.
7. Raise the Workstation a short distance. If you can't easily move the Workstation
upwards or it begins to move downwards when you squeeze the paddle, you need
to adjust the tension. For more information about how to do this, see the "Adjust the
tension of the Workstation" section of the manual.
8. Position your equipment cables so that they run through the loops located at the
back of the Workstation. (figure 5)
9. If necessary, reposition the keyboard tray. For more information about how to do
this, see the "Reposition the keyboard tray" section of the manual.
Adjust the tension of the Workstation
Warning! Remove all equipment from the Workstation before you begin to adjust the
tension.
1. Carefully remove all of the equipment from the Workstation.
figure 5
Instruction manual
10
Cables
Loop
Publicidad
Tabla de contenido
