Dismantling The Tent - Crivit 330568 1907 Instrucciones De Utilización Y De Seguridad

Make sure ventilation openings (includes the
outer door) are open all the time to avoid
suffocation.
Keep the exit free! Do not block the exit with
objects.
DANGER OF SUFFOCATION!
If the inside of the tent is not adequately venti-
lated, there is a risk of suffocation.
Fire precautions
Camp safely. Follow these common
sense rules:
Do not place hot appliances near the walls, roof
or curtains.
Always observe the safety instructions for these
appliances.
Never allow children to play near hot appliances.
Keep exits clear. Do not block the exit with
objects.
Make sure you know the fire precaution arrange-
ments on the site.
Take note of the effects of the weather
and climate
When selecting the location to put up your tent,
you should always consider the local situation
and how this might change. Will the terrain turn
into a lake if it rains? Please take into account
any rising rivers and incoming tides.
Protect the product against strong wind and
storms. Place the product in a location that is
protected from the wind if possible.
If a strong wind is forecast, replace the normal
tent pegs with special storm pegs. You can find
information about meaningful supplementary
products at specialist shops.
The tent should be taken down before heavy
snowfall or stormy weather.
Remove any snow directly from the product.
Otherwise the product may collapse under the
weight.
Ensure that the tent is not too taut when it is
erected, otherwise it may not be able to adapt
to changing weather conditions and might be
damaged.
18 GB/MT
Zips are wearing parts and do not fall under
the guarantee conditions.
The polyester material of the tent consists of
water-repellent material.
It is possible that during the first rainfall the tent
will not be completely watertight. However, the
threads of the tent will contract when exposed
to water so that after a short time the tent will
become watertight.
When exposed to moisture and rain, tent fabrics
expand to varying degrees and make it neces-
sary to adapt the length of the guy lines. If the
material becomes taut again while drying, the
guy lines have to be loosened again in good time.
Do not use any insect spray in or on the tent.
Small leaks on the seams can be repaired with
a seam spray and impregnation spray can be
used for the tent skin.
Assembly
Please ensure that the product is only assembled /
disassembled by a competent person.
Erecting the tent
ATTENTION: Please note that the poles are under
tension and snap into the natural shape of the tent.
Taking care that the release of tension does not
cause any injury.
Remove the rubber band and throw the product
away from you into the air.
Set up the tent with guy lines
(see fig. H).

Dismantling the tent

Please watch the tent dismantling information
video by using the QR-code with a suitable
appliance.
Grasp the centre of the upper hoops in one
hand and pull the centre points of the lower
hoops up to them. Start at the rear end of the
and pegs
2 3