Power Saving Mode - Smanos MD2300 Manual Del Usuario

EN

Power Saving Mode

The product features power-saving design. If the detector detects
human movement twice in 3 minutes, it will switch to the sleeping
state to save power. At this time, the LED will not flash and no alarm.
After no movement within the next 3 minutes, the detector switches
back to the working state automatically.
Case 1: Initial start and then enter
into test mode.
Sleep after detecting human movement twice
Switch from sleep to arm.
Note: After the detector is in the sleeping state, ensure no human movement
within 3 minutes; otherwise, the detector remains sleeping.
In the sleeping state, it is recommended that you leave the room after arming
the system. Ensure no human movement in 3 minutes. Then, go into the room,
the system alarms immediately.
Case 2: Press the test button and
then enter into test mode.
3 minutes later
No human movement
within 3 minutes
Installation
After making sure the detector works normally, do as follows:
1. Choose a suitable
installation location
It is recommended to
mount it at the height of 2
m from the ground.
2. Fix the detector
Fix the bracket on the wall with screws and attach the detector to
the bracket. Or user can stick it at the corner with double-sided
tapes.
EN
2.2-2.5 m
Ground