Lcd Display - Akasa all in one 2 Instrucciones De Instalación

LCD Display

Fan speed Temp. reading
display indicator
Temperature
display
Temperature display
Displays current temperature of the indicated sensor (T,T or T3)
Fan speed display
Displays current RPM of the indicated fan (FAN,FAN  or FAN3)
Fan working display
If fan is working correctly the green indicator will spin
Mode switch indicator
Indicates current fan control mode (automatic or manual)
Fan speed display
Indicates fan voltage from 6V (one bar) to V (seven bars)
Low speed or overheat alarm
If fan speed is below set alarm value or the temperature is above the set
alarm value the red CAUTION indicator will blink and alarm will sound
(The alarm will stop after 5 sec. Red CAUTION will flash until the
problem has been rectified)
9
Mode switch
indicator
Alarm Fan working Fan speed Fan reading
indicator display display indicator
Operating Fan Control
reset
mode
Function
RPM
Adjust fan
Button
Press once to change temp
reset
o
units between C or
Changes display between
mode
Fan and Temp ,  or 3
Increase fan RPM
+
(manual mode)
Decrease fan RPM
-
(manual mode)
Setup Mode
Press for  sec to enter or
o
F exit setup mode
Selection: Fan / Temp / Fan
/ Temp / Temp3, Fan3 / Auto
selection
Increase alarm value
(min. RPM or max temp)
Decrease alarm value
(min. RPM or max temp )
0