Led Display Of Functions; Reset Repeater - Gigaset Repeater 2.0 Manual De Instrucciones

When looking for a suitable installation site, a useful guide is a handset which requires a good connection
with the base station at the Gigaset Repeater installation site.
¤
To operate a handset for the first
time in the extended Gigaset
Repeater area, switch off the
handset within the new reception
range of the Gigaset Repeater, but
outside the reception range of the
base station, and then switch it
back on again.
If you are using more than one Gigaset Repeater in the area of your base station, you must keep
the Gigaset Repeaters at least 10 m apart.
Operation

LED display of functions

Left LED: display registration and operation function
In operation Light off
Constantly on
Flashing
Not yet Flashing twice per
second
registered
Light off
Right LED: displays the handset traffic via the repeater
In operation Light off
Flashing once every 3
seconds
Flashing twice every 3
seconds
Constantly on

Reset repeater

If registration was not successful or re-registration has to be carried out for another reason, you can reset
the repeater as follows.
¤
Press repeater button (left LED flashes slowly).
¤
Release repeater button once the left LED flashes quickly (after approximately 10 seconds).
The repeater is ready for registration once again.
16
Base station
power supply off
normal link to base station
no link to base station
ready for automatic registration
automatic registration unsuccessful after 5 mins
no traffic
one handset linked via repeater
two handset linked via repeater
base station not prepared for operation with a repeater
(does not apply to base stations where Repeater Mode can be
switched off and on)
Extended
reception